1988 brougham speedometer cable
#2
RE: 1988 brougham speedometer cable
1. remove instrument panel insert.
2. remove speedo cluster.
3. disconnect cable housing from locking spring on mounting plate and pull through firewall.
4. disconnect cable at transmission.
5. remove cable assembly.
6. connect new cable to trans. first.
7. route cable up through engine compartment using retaining clips.
8. route cable through grommet in firewall (protect cable end while forcing through firewall)
9. fasten cable to cluster and put dash back together.
2. remove speedo cluster.
3. disconnect cable housing from locking spring on mounting plate and pull through firewall.
4. disconnect cable at transmission.
5. remove cable assembly.
6. connect new cable to trans. first.
7. route cable up through engine compartment using retaining clips.
8. route cable through grommet in firewall (protect cable end while forcing through firewall)
9. fasten cable to cluster and put dash back together.
Thread
Thread Starter
Forum
Replies
Last Post
CrusinCaddy83
Private 'Wanted' Classifieds
0
01-07-2008 02:20 PM