Winshield Wiper
#1
Winshield Wiper
This moring after and ice storm I turned on the windshield wipers (car was outside). One wiper moved and did its job the other did not. I assume the drivers side wiper is stripped. So what has been the best remedy for this problem. I can think of three
1) Get a new arm
2) Drill a hole in the old arm and wiper motor stud and put a roll pin in it
3) Lock tight the arm and motor stud with bearing and stud loctight
Can anyone else think of any better solutions?
1) Get a new arm
2) Drill a hole in the old arm and wiper motor stud and put a roll pin in it
3) Lock tight the arm and motor stud with bearing and stud loctight
Can anyone else think of any better solutions?
#2
RE: Winshield Wiper
You will probably have to get a new arm. I have seen several situations similar to that and in the end just got a new arm. Luckily the posts that the arm is attached to usually stand up to the stress better then the arm and doesn't need replacing. I would rather buy a new arm then try to fix it by any other mean so I would know thatif my wife is driving down the highway in the rain with the wipers on high the arm won't come off.
Thread
Thread Starter
Forum
Replies
Last Post