i did clear all the codes before i programed the new key

 

are u using the on board system to check for codes or using a code reader
u did the three 12 minutes relearn then turned off vehicle then tried to start and no go

is the security light on or off
after u turn the key does it stay on
sometimes doing it the way u did it does not always take it the first time

 

Im using the onboard reader... the security light is acting as it should now... not on when the key is in the ignition... after the third cycle it volunteered that the starter was disabled in the display... i am trying the three cycles again...

 

and there is a clicking noise now when the tumbler is moved to the start position... but still no start... could it be the theft deterent module... by the by i did a onboard code read today and the AMP, IPM, IPC and RCC circuits all report a b1004 code current...

 

im sorry the rcc was b1009

 

If this DTC is retrieved as either a current or a history DTC, replace the module.
Step
Action
Value(s)
Yes
No
1
Did you perform Diagnostic System Check - Body Control System ?
--
Go to Step 2
Go to Diagnostic System Check - Body Control System
2

1. [*]

Is DTC retrieved as a current or a history DTC?
--
Go to Step 3
Go to Testing for Intermittent and Poor Connections in Wiring Systems
3
Replace the module.
Did you complete the replacement?
--
Go to Step 4
--
4

1. [*]

Does the DTC reset?
--
Go to Step 2
System OK

 

basically its telling u the module is no good
need to replace it