General Tech Good at troubleshooting? Have a non specific issue? Discuss general tech topics here.

2000 Deville base model no start

Old Dec 19, 2011 | 07:42 AM
  #1  
brianlofton's Avatar
Thread Starter
|
Junior Member
Joined: Dec 2011
Posts: 12
Default 2000 Deville base model no start

The security light flashes when I try to start the car and there is no sound of a fuel pump and the starter doesn't even try to kick. I have disconnected the battery for fifteen minuites and tried again. I have also tried many combinations of unlocking and locking the doors to include activating the panic button on the key fob. It was fine when I parked it and now de-nada... please help I have work in a few hours...
 
Old Dec 19, 2011 | 09:13 AM
  #2  
brianlofton's Avatar
Thread Starter
|
Junior Member
Joined: Dec 2011
Posts: 12
Default

it threw a bunch of codes faster than i could write them... pcm p0171 1860 0174 0335 0336 0340 0341... irc v1301 ipm b1004 ipc b1004
 
Old Dec 19, 2011 | 09:48 AM
  #3  
gmtechs's Avatar
Senior Member
Joined: Aug 2010
Posts: 239
From: Ontario
Default

right now the problem u r having is the security light, first make sure battery is fully charged and the connection are good
 
Old Dec 19, 2011 | 09:50 AM
  #4  
gmtechs's Avatar
Senior Member
Joined: Aug 2010
Posts: 239
From: Ontario
Default

after u do this try to start the car , turn to crank and let key go back to the position as if the car started leave it there for 10- 15 minutes the security light should stop flashing turn off vehicle and then try restarting it
 
Old Dec 19, 2011 | 10:45 AM
  #5  
brianlofton's Avatar
Thread Starter
|
Junior Member
Joined: Dec 2011
Posts: 12
Default

Ty i will do this now
 
Old Dec 19, 2011 | 12:07 PM
  #6  
brianlofton's Avatar
Thread Starter
|
Junior Member
Joined: Dec 2011
Posts: 12
Default ok...

Battery was wrong size all together got a new battery and installed... no security light inappropriately but no start... have just started without starting the car and left KO for the 10-15 min you mentioned
 
Old Dec 19, 2011 | 12:35 PM
  #7  
brianlofton's Avatar
Thread Starter
|
Junior Member
Joined: Dec 2011
Posts: 12
Default

it didn't work
 
Old Dec 20, 2011 | 07:30 PM
  #8  
gmtechs's Avatar
Senior Member
Joined: Aug 2010
Posts: 239
From: Ontario
Default

clean all codes
so no security light
when u put key in does it go on then off
 
Old Dec 20, 2011 | 07:36 PM
  #9  
gmtechs's Avatar
Senior Member
Joined: Aug 2010
Posts: 239
From: Ontario
Default

if the code b1004 does not leave then module is no good
 
Old Dec 20, 2011 | 08:29 PM
  #10  
brianlofton's Avatar
Thread Starter
|
Junior Member
Joined: Dec 2011
Posts: 12
Default phew

Ok today I went and got a new key cut... after the three key on key off cycles to program the car to the key, the dash display said "starter disabled" ???
 

Thread Tools
Search this Thread

All times are GMT -5. The time now is 01:09 PM.