Working on a 1993 Fleetwood Hearse with a 350 TBI. It is a no start and I am following someone else's work. Fuel pressure is at 10 psi. Found the plug wires in the wrong order, fixed that. Spark was weak. Distributor cap had been installed crooked and there was wear inside from the rotor rubbing. Replaced cap & rotor. Still no start. Spark still seemed weak. Checked resistance on the coil, checked good to spec. Replaced the ignition module because I remember they could be a problem. (Haven't seen a tbi engine in over a decade) Still no start. Took a video of the throttle body while trying to start and saw that the injectors are not firing as they should either. I believe the pickup coil on the distributor gives the signal for Spark and injector so I am trying to remove the distributor BUT there isn't enough room between the motor and the cowl to get it out. Looks like somebody before me tried to get it out because the baseplate that the cap screws to is bent. Is there an easy way to get the distributor out?