I just installed an ISC motor on my 1992 Allante and I can't find any information reguarding how to reset the computer to get my car running correctly again. Any help on the matter would be greatly appreciated. I have tried taking it on a twenty minute test drive over 40mph (suggested by a website i came accross) to see if the computer would re-teach itself, but that didn't work, and I've tried pulling the fuse for the ECM and waiting five minutes, but that didn't reset the computer either. Thanks in advance for any possible solutions.

 

turn on ignition (not engine) for 30 seconds
turn off ignition for 15 seconds
start engine
go for the drive.

.....

maybe you missed it but there is an Allante FAQ in this site




.

 

Thanks, for the heads up, I'll look for the FAQ section. I haven't really had time to sit down and check out all of the stuff this site has to offer. I'll try the procedure you in your message. Thanks again.