Hi
sorry for my English. I write as I know
Want to submit your project
decided to write a small photo report on installing a full-fledged computer in CTS 1
On each of my last car - it was something like that! But mostly it was the integration of the IPAD. Here by the way the most recent project is the replacement head for VW PASSAT B6 - and everything worked - even the buttons on the wheel )) but I wanted to put something else)
On my head unit - totoralillo idle, after installing a head unit with monitor from SRX1:


Next cut:




shaping the future under the hole for the display:


next, putty and painting

and that's what eventually happened:


and finally all dried up and the monitor was glued to two rightful place:


Missed the layout of the "system unit"!
All good is placed in a regular box from the radio.
Remove the bottom part of the box ( it does not , first wanted to cut holes under the plugs , but thought that the heat would be better without cover ) to the back fasten the motherboard to the power supply, to the side of the hard drive


Ну и ближе к лицевой части - устанавливаем плату бортового компьютера авто
Выглядеть это должно примерно вот так :


all collected:


Here's what happened (while on the table, not in the car):

Here's what happened:


1 Launch Of The CarPC :

2 Any TV channel in motion) :

another useful feature
analogue of Apple TV:

finish