'98 STS Service Suspension Sys after mount replacement
#1
'98 STS Service Suspension Sys after mount replacement
I'm getting a 'service suspension sys' message on my 98 STS. Looking at the codes, both C1760 and C1761 are showing as current. This seemed to start right after I had the front engine mount replaced. I'm looking for any ideas on what could cause the errors and whether it could be related anything done when the mount was replaced. Thanks. AJ
#2
Front position sensors disconnected from lower control arms or link end pulled off rods. If you turn wheel fully the sensor arm is fairly visible when viewed from the front. Make sure link is attached from sensor to control arm on both sides.
Thread
Thread Starter
Forum
Replies
Last Post
Petey78
Suspension sponsored by Arnott Inc.
0
03-04-2013 01:24 AM