|
G.A.R.Y. -> RE: brakes hard (2/18/2007 1:21:56 PM)
|
quote:
ORIGINAL: dave hi this is the first time iv,e used this site. wounded if anyone could help me?a freind of mine has bought a cadillac allante 1990!!!.and this is first time i,ve worked on this type of car.the brakes have failed,the pedal is rock hard!!!! no assistance.i had a breif look on the net and found a couple of trouble shooting methods. i have cheked for fault codes and it gave me.E0521 history,R051 history,B448 history,and B552 history.this is all could get out of the diagnotics via the a/c contol unit? i tied bridging pins A+H on the diagnostic plug but the brake light on the dash would not flash it stays on constantly?also on the dash it tells me the abs and the traction is disabled? i think i disabled it by carring out checks i found on the the net!!! it told me to disable the pressure by pumping the brake pedeal 25 times wih ignition off then to check how long the pump runs for?this was suppose to only run fot about 30 seconds but it runs constantly until igniton is switched off?after i did this i found the brakes worked fine for about 30 seconds but then failed again!!! would be gratefull if anyone could help me out!!!! I doubt that you disabled traction contol by doing checks. You CAN disable traction control for 11 ignition cycles on the 93, not positive about the 90. Your brake situation makes the auto unsafe to drive. Resident expert D. hussey is the best source I am aware of regarding the brakes on pre '93's. Good luck. G.A.R.Y.
|
|
|
|