RE: 95 seville overheating dead end

Cadillac Forum Cadillac Classifieds Photo Gallery Member List Calendars Search Contact CF Sponsors
Cadillac News Forum FAQ Cadillac Timeslips Cadillac Recalls TSBs Register Login

RE: 95 seville overheating dead end

Printable Version

Cadillac >> Cadillac Models >> Cadillac Seville >> RE: 95 seville overheating dead end

Page: << < prev 1 [2]

Message

<< Older Topic Newer Topic >>

RE: 95 seville overheating dead end - 7/3/2008 4:08:55 PM

oneida_6

Posts: 4
Joined: 7/1/2008
Status: offline

that is a good suggestion on the water pump ... i was thinking of doing that anyways if nothing else to eliminate possiblities. But i brought it to a shop this morning and at first they couldn''t even get it to over heat

but after the longer road trip <which i said it would take> they got it to and told me that while it was hooked up to there computer the dash wouuld say 255 but there computer <hooked up to my cars computer> said it was only running at 226. which i beleave is where it should be. Which would mean it''s just the sensor. so now i have to wait a couple days for the ordering of the part and the weekend. i thought about just takeing my car back and doing it myself but i figured i would atleast have them do that much for me sense they found the problem for me ... i hope that is the problem. .. i origianal didn''t think this was the problem because i could hear the water bubbleing in the resivore and it seemed to be running hot. but i guess if it runs at <high end> 225 and water boils at 212. .. i guess it would be bubbleing a bit, lol thanks again for all the suggestions much appreciated

(in reply to Katzmans Caddy)

Post #: 11

RE: 95 seville overheating dead end - 7/3/2008 4:14:00 PM

Katzmans Caddy

Posts: 1078
Joined: 12/3/2006
Status: offline

225 would be the highest consistent reading we like to see. Did the car ever kick into Limp Home mode, I think that is 248? If not I think the sensor might be an issue BUT you are losing coolant too remember..

(in reply to oneida_6)

Post #: 12