I HAVE 3RD GEAR ONLY 95 seville 4.6 sts
#1
I HAVE 3RD GEAR ONLY 95 seville 4.6 sts
95 seville 4.6 sts
I have tried to figure this problem out by reading and looking at diagrams , but no luck.Fluid is unburnt and to correct level.
My problem is, that after warming up to operating temps I loose 1,2 ,and 4 gears. i have a code P056 which I guess means that I need a Input speed sensor. What is puzzling me is that I can not see anyone else with my exact problem. When the car is cold, it all works great. i did have a few telltales leading up to this. Sometimes at a light , when applying power to move, it would JUMP into gear.It did always seem to be starting out in 2nd gear. I am moving towards replacement of this sensor but just need a little nudge to do it. I did replace the speed sensor on the pass side of the tranny and no change. One last request, can I replace this by removing the side pan only or is it into the next casing?Thanks for any help given.
I have tried to figure this problem out by reading and looking at diagrams , but no luck.Fluid is unburnt and to correct level.
My problem is, that after warming up to operating temps I loose 1,2 ,and 4 gears. i have a code P056 which I guess means that I need a Input speed sensor. What is puzzling me is that I can not see anyone else with my exact problem. When the car is cold, it all works great. i did have a few telltales leading up to this. Sometimes at a light , when applying power to move, it would JUMP into gear.It did always seem to be starting out in 2nd gear. I am moving towards replacement of this sensor but just need a little nudge to do it. I did replace the speed sensor on the pass side of the tranny and no change. One last request, can I replace this by removing the side pan only or is it into the next casing?Thanks for any help given.
Thread
Thread Starter
Forum
Replies
Last Post
Macko11586
General Tech
0
06-16-2009 10:40 AM
wpbrink
General Tech
1
08-03-2008 11:56 AM
stomper
Off Topic
0
11-30-2007 10:11 AM